I went to alignment shop today and my front camber was pretty much out of spec. I have the cusco front A-arm and i guess that didnt help my camber much. Well, my coupe is dropped about 1 finger gap all around and theres one solution that the shop offered. He said he can bend my front camber back to spec . So my question is should i let the shop do it? is there any downfall to it? has anyone done this or heard of this before? thanks for the help!

 

no, don't bend anything. your cusco's only provide +0.25 or something,
right (those are meant to provide more neg camber than positive). just
get your L/R within 0.1 degree, toe 0.05 each side on the front and call
it a day.

make sure your rear toe are 0.10 each side or more.

 

kenchan, can u tell me what kine of camber kit would be good if u have to fall back into OEM specs and dropping 1.5-1.8 inches? thanks (sorry for jacking)

 

Do not bend!

http://www.350z-tech.com/zwiki/User:...rmsFinal_Drive