Sorry folks I never got to finish this mod I did half of it and the rest I gave the guy who original provided me with the wiring diagram and how to. My lights are working properly.

 

I completed this mod its pretty tedious although i didn't take any pictures while doing it. If anyone in the GTA needs this done you can PM me

Edit: For my lights i did everything so it works 100% percent along with DRL's I also ended up doing a few custom things to the lights

 

hey are you good with the solder? I need someone to solder one of the wiring because is a little loose.

 

Heres a link to the thread of my headlights
Custom Headlights

Yah im pretty good with the solder although i need to pick up a new one becaue my other one is old and worn out

 

there is a h1 for the high beams?

I am going to try to attempt to install the relays for the drl. i will take pics. I hope this wire diagrams works also that i hope it understand it by looking at it. i can make out most of it out

 

H1 isn't the high beams the projector acts as your High beams by using a sheild.

On a side note i rear ended a van 2 weeks after i installed my lights and ended up cracking one of the lights but i am installing a bunch of parts including a new set of lights

 

I have done the mod. But i don't know if it is working right.

High beams work
fog lights work
signal work
dlr work

I want the signal to keep on when it is not in use.

 

I managed to blunder my way through the conversion as well.. The only thing not working is my DRL's and I don't know why. I am just going to pull the fuse and call it good.

 

did you cut pin 1 2 and hook up wires that are going to light not from harness from relay #30 from both relays to them

 

I just realized that when i put to auto it will not shut off any one have this probelm

 

my drls are my only problem thus far.. I hope pulling the fuse will make it ok.

 

if you need help i can help you just pm and i will give you my msn

 

Guys,

I don't visit the regional forum very much... I am surprised to learn that people are still having difficulty with this mod.

If you are not use to reading an electrical schematic, them I would recommend that you take it to your local auto stereo installation shop. They should be able to help you... and it should take you at most 2 hrs (if you are **** about how you make the mods).

I will try answer any questions but it is very difficult to explain over messenger/telephone if you are not familiar with cutting, stripping and soldering wires.

For those of you in Ottawa, I can mod your headlings for you.

Good luck

Larry

 

so did anyone other than godzilla and larry make a sucessful conversion with everything working?

 

Hey guys - I have 06 projector headlights and happen to live 2 minutes from Larry's house. I'm getting together with him next week and I'll put up a complete DIY for this mod.