Lots of random stuff. He's trying to cut down on material before moving it into his house. Prices are pretty good right because of that. http://www.synfxonline.com/

 

Thanks! Man... I did it ghetto. After two or days of looking and thinking there really was no good way to mount them and show them off how I wanted to. So I basically just drilled into the support. I'll take a picture and post it here after 5pm.

 

OK, sorry for the whoring. I went out and tripped over my spacers by the door





Unfortunately (or fortunately depending on how you look at it) I have HKS Hypermax coils and the rears are maxed out except for about 1/4'' inch left to lower... I'll just try to not stretch as much since I can't go any lower right now.... -5 camber to squeeze in 275's and 0 offset ftw! I ordered front spacers separately so they haven't come in yet.

 

Yup. I'm -3.5 up front and -4.8 out back (I was pretty pissed at this seeing as how I bought front front and rear SPC camber arms... only to be so far out of spec).

 

Here is that pic of where I attached the horns. I didn't take an actual pic of my car.

Borrowed member "meatbag"s photo instead! Circled in red is where I drilled.

[IMG][/IMG]