Oh and I tried to widen the bell mouth for every runer by 1mm per side....witch proved to be very difficult since I didn't really want to reshape them. Maintaining the curves that were designed into the inside of the bell mouths without messing them up wasn't easy.

 

haha I can testify to the patience required to do this. I still may get another one and redo mine, I'd like to see if there are any gains to be had out of staggering the runner cut offs..

 

Rob, had i known about your dyno stuff i wouldve sent you a set up. all 3 parts. The dyno gains from this with a tune and piggy back ecu are good. They have ranged from 260s to 280s on both rev up and non rev up. Pm me if youve got any questions. And do me this favor. When you mate the 2 lower parts look at the flow from the front of the set up. and if you can imagine taking a 1/2 inch out of the center section and imagine the flow. It goes from almost looking like an s to looking like an x. i dont mind sharing all this stuff just let me know. Mike

 

I would be down for anything Jeramya if you need some testing/buyer on heads. just let me know

 

I will man. May take a while tho. Got a project mustang going on right now too.

 

no worries!