Throw out bearing issue
Thread Starter
|
Registered User
Joined: Jan 2016
Posts: 16
Likes: 0
Oh boy... I didn't realize what you bought was grade A ebay shiz. Not good batman.
It's a 6 puck too... I wouldn't expect to get more than 40k out of this clutch.
Honestly that was a terrible purchase. Next time, check out Z1 motorsports clutches and flywheels or JWT. They are full face, and whatever numbers they claim will be 100% true. Can't say the same about the XTD crap.
What mods would require a stage 3 clutch? Well, what I saw on ebay rated your clutch for over 475ft lbs of torque. Unless you have $30+k laying around, you'll never get to that. But that's assuming those numbers aren't complete BS because well, it's an ebay clutch. To get to that torque you would need a turbo system, fuel system, completely built bottom end, and a lot more.
It's a 6 puck too... I wouldn't expect to get more than 40k out of this clutch.
Honestly that was a terrible purchase. Next time, check out Z1 motorsports clutches and flywheels or JWT. They are full face, and whatever numbers they claim will be 100% true. Can't say the same about the XTD crap.
What mods would require a stage 3 clutch? Well, what I saw on ebay rated your clutch for over 475ft lbs of torque. Unless you have $30+k laying around, you'll never get to that. But that's assuming those numbers aren't complete BS because well, it's an ebay clutch. To get to that torque you would need a turbo system, fuel system, completely built bottom end, and a lot more.
So next clutch dont do 6 puck . My other clutch was shot regardless so hadda be done lol
-____- and i was gonna Boost it too . But was gonna wait but no point to wait now i guess huh lmao
Thread
Thread Starter
Forum
Replies
Last Post