Throwing Code PO345
#1
Join Date: Feb 2008
Location: DeSoto (Dallas), TX
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
Throwing Code PO345
So I have been having an issue with my 03 G-Coupe. Its been starting up with the check engine light on, but after a while, in gear, the car to stall intermitently, then jumps back into gear after a couple of seconds. Then the VDC and Slip lights came on with the CEL. After this, when the car was turned off and restarted, it would turn over for a few seconds before actually starting. But this would go away after the car sat for a little while.
Now the engine turns over for a few seconds before starting and starts up with all three lights on, even if sitting overnight.
I got the code checked, and its throwing the Cam Position Sensor P0345.
Also, in a likely related issue, my engine has been drinking oil. I added 2qts 2 weeks ago and it was dry when my mechanic looked at it the Friday.
With these combined issues, what am I looking at? From what I've read on the forum, if it wasn't for the oil issue, I would just replace the sensors. But now I'm not so sure.....
Cars mods are Z-Tube, Pop Charger, and JWT Clutch and Flywheel.
Now the engine turns over for a few seconds before starting and starts up with all three lights on, even if sitting overnight.
I got the code checked, and its throwing the Cam Position Sensor P0345.
Also, in a likely related issue, my engine has been drinking oil. I added 2qts 2 weeks ago and it was dry when my mechanic looked at it the Friday.
With these combined issues, what am I looking at? From what I've read on the forum, if it wasn't for the oil issue, I would just replace the sensors. But now I'm not so sure.....
Cars mods are Z-Tube, Pop Charger, and JWT Clutch and Flywheel.
#3
Join Date: Feb 2008
Location: DeSoto (Dallas), TX
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
#5
Join Date: Feb 2008
Location: DeSoto (Dallas), TX
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
FML!
Anyway, as a backup, does anyone know of someone who sells VQ longblocks built to not consume as much oil in TX? I would rather get a new engine than buy a new car.
Thread
Thread Starter
Forum
Replies
Last Post
RemmyZero
V36 DIY
10
04-23-2018 11:13 AM
Learned Hand
G35 Sedan V35 2003-06
1
10-01-2015 09:02 AM