I am a recently new owner of a fully loaded 2003 g35 6mt with 67000 miles on it! Unfortunatly I blew my motor driving from north carolina to yuma arizona and it happened in georgia. My water pump went out and some weirdo guy offered to replace it and as I was on a time crunch to make it to my duty station in time I agred and took off the next day and same thing happen in the exact same spot on the freeway I want to rebuild it I also want to bore it out as I am already going to be tearing it down but I want a package deal where I can buy almost everything together....any suggestions?

 

dang sorry to hear that.. gl though

 

do you know the reason why the pump broke?

 

I have no clue it broke twice though and I started hearing a noise a little bit after I got it and I took to some people and there like oh its normal or oh its one of the pulleys bearings going out so I was like **** and outta no where it stopped and I fogot about it and started my drive and sure enough it went out but now the whole bottom end is blown and has horrible acceleration and lots of noise I just wanna do a mild build on it a little more than stock so eventually I run FI but I'm going for the recommended compression rather then FI compression I have access to any tool lift shop but it would be cheaper for me to do it rather a shop so I'm clueless as of now lol

 

ls2 is your friend.... you will be happy you did

 

Ls2......major modification right? My father has a 2000 vette with the ls1 but wouldn't that take a lot of fabrication of moving mounts and sure it would fit?

 

https://g35driver.com/forums/forced-...rbo-build.html

 

Ok so engine tranny? Drive train? Right

 

and ecu....yep it can be done as long as you have the funds.

 

are you still in georgia? did your car go down anywhere near marietta?

 

No I paid for a uhaul and trailor and hauled it to yuma arizona it went down in augusta