Not sure what's wrong. Doesn't run...
#1
Not sure what's wrong. Doesn't run...
A few weeks ago I drove my 2006 AT Coupe and everything was fine. I went to start it up recently and it idles horribly and almost immediately dies. I'm getting no codes.
It runs in limp mode with MAF sensor disconnected.
I changed the PCV Valve and MAF sensor but neither fixed the issue.
When MAF is disconnected it throws codes but none when it's connected.
FYI, I have a Vortech supercharger.
I'm stumped. I was thinking cam shaft and crankshaft sensors but everyone says that those should throw DTC codes if they are bad.
Any thoughts?
It runs in limp mode with MAF sensor disconnected.
I changed the PCV Valve and MAF sensor but neither fixed the issue.
When MAF is disconnected it throws codes but none when it's connected.
FYI, I have a Vortech supercharger.
I'm stumped. I was thinking cam shaft and crankshaft sensors but everyone says that those should throw DTC codes if they are bad.
Any thoughts?
Thread
Thread Starter
Forum
Replies
Last Post
RemmyZero
V36 DIY
10
04-23-2018 11:13 AM
Learned Hand
G35 Sedan V35 2003-06
1
10-01-2015 09:02 AM