LS2 intake flange on VK56DE intake?
Thread Starter
|
Registered User
Joined: May 2011
Posts: 99
Likes: 5
From: CT
LS2 intake flange on VK56DE intake?
Hey everyone.
I am picking up an LS2 Intake, which is 90 mm, and I will be working on grafting it to a VK56DE intake. The entire reason for this is because of my other thread and build and the VK has a smaller TB. I just measured the inner diameter, 75 mm. So Basically it will take me from a 3 in to a 3.5 inch TB. I am not worried about going super crazy and doing a 102 mm cause I will being going SC in the long run in the end so this would be for the NA intake.
My question for the community is this.
Do you want a Documented build up of this so that you can take a look and give is a shot if you like?
I am picking up an LS2 Intake, which is 90 mm, and I will be working on grafting it to a VK56DE intake. The entire reason for this is because of my other thread and build and the VK has a smaller TB. I just measured the inner diameter, 75 mm. So Basically it will take me from a 3 in to a 3.5 inch TB. I am not worried about going super crazy and doing a 102 mm cause I will being going SC in the long run in the end so this would be for the NA intake.
My question for the community is this.
Do you want a Documented build up of this so that you can take a look and give is a shot if you like?
Thread
Thread Starter
Forum
Replies
Last Post
ninjabong
Brakes & Suspension
2
Apr 22, 2016 11:52 AM
jbmw002
G35 Sedan V35 2003-06
3
Mar 10, 2016 12:06 PM
