no crank
#1
#3
There is no code. It's like the engine is locked but when I opened it up everything was still in its place nothing was loose or out of place. Pistons were still there no holes in the block so now I'm just stuck. Could it be the engine is vapor locked and the pressure would cause the engine to not turn over?
#4
Join Date: May 2017
Location: Washington State
Posts: 14,799
Received 2,461 Likes
on
2,153 Posts
Coupe 6MT Premium RAS
What about turning it manually from the crank pulley? If you can't spin the engine by hand then SOMETHING is locked up.
Pull the spark plugs, that way there's zero chance of a hydrolocked cylinder that's preventing you from turning it.
If it still won't turn then pull the access cover opposite side of the block from the starter and see if there's carnage in the bellhousing preventing the flexplate from turning.
If everything checks out then it's probably a spun crank bearing, drain the oil and look for glitter.
Pull the spark plugs, that way there's zero chance of a hydrolocked cylinder that's preventing you from turning it.
If it still won't turn then pull the access cover opposite side of the block from the starter and see if there's carnage in the bellhousing preventing the flexplate from turning.
If everything checks out then it's probably a spun crank bearing, drain the oil and look for glitter.
#5
Thread
Thread Starter
Forum
Replies
Last Post