Need advice...problem screw broke.
#1
Join Date: Nov 2005
Posts: 835
Likes: 0
Received 0 Likes
on
0 Posts
Need advice...problem screw broke.
I was installing my 1/2 plenum spacer with ISO thermal gasket...when i was putting the lower plenum back together, and i guess there was a malfuntion in the torque wrench i bought and it ended up torqeing my intake maknifold collector screw too much and cracked it, i was wondering is it safe to put my engine back together until i get the screw or should i just wait and not risk having one screw not in?
Last edited by ZLUJ; 01-31-2006 at 12:18 AM.
#2
Ouch! Hmmm . . . That's 1 of 6 bolts, which bolts down the lower collector directly to the intake manifold. If it were me, I'd wait til I got a replacement bolt and avoid a potential problem. Good luck!
Btw . . . Just to be sure, you used an inch-lb. torque wrench with a final setting of 100 inch-lb., right?
Btw . . . Just to be sure, you used an inch-lb. torque wrench with a final setting of 100 inch-lb., right?
Last edited by Andy2434; 01-31-2006 at 12:23 AM.
#3
Join Date: Nov 2005
Posts: 835
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by andy2434
Ouch! Hmmm . . . That's 1 of 6 bolts, which bolts down the lower collector directly to the intake manifold. If it were me, I'd wait til I got a replacement bolt and avoid a potential problem. Good luck!
Btw . . . Just to be sure, you used an inch-lb. torque wrench with a final setting of 100 inch-lb., right?
Btw . . . Just to be sure, you used an inch-lb. torque wrench with a final setting of 100 inch-lb., right?
yes i used an 1ch lb torque wrench...somethign was wrong with the wrench, it wasnt it was a cheap one that has like a needle type of deal and the needle moves accordingly to how much the bolt is torqued.. the hell wiht that one.. i just bough another one.
Thread
Thread Starter
Forum
Replies
Last Post
RemmyZero
V36 DIY
10
04-23-2018 11:13 AM
Ninjay16
Audio/Video/Electronics
11
02-26-2018 06:14 PM
jbmw002
G35 Sedan V35 2003-06
4
09-10-2015 12:54 AM