FS: HKS carbon TI 2 piece single exhaust and japtrix y-pip
Joined: Dec 2007
Posts: 202
Likes: 1
From: SO.CAL/ S.A TX
HKS carbon TI 2 piece single exhaust and japtrix y-pip
Well I hate to do this but I am ready to sell my single HKS carbon TI exhaust. The exhaust has been on my car for alittle less then a year. I had the exhaust made to look like the agency single so it is a two piece exhaust. The exhaust sounds amazing and is pretty loud. I already miss the sound but I already installed a replacement. There are some scratches on the bottom of the canister from when I was lowered on coilovers but they are not noticeable when installed. I have the exhaust angled perfectly so there are no issues with it leaving black residue on the rear bumper.
Exhaust specs
2 piece exhaust
3" piping.
HKS carbon TI muffler 120 mm tip
Japtrix y-pipe
Inlet = 2.5" Outlet = 3"
Since the japtrix outlet is 3" it mates perfect with the exhaust so you have no back flow. I believe the japtrix y-pipe is discontinued so they are hard to come around
I wish I had a sound clip but unfortunetly I dont.
Here are pictures of when I first got it built



Current pictures




y-pipe SOLD
Exhaust 500 shipped+ pp fee
450 picked up
Exhaust specs
2 piece exhaust
3" piping.
HKS carbon TI muffler 120 mm tip
Japtrix y-pipe
Inlet = 2.5" Outlet = 3"
Since the japtrix outlet is 3" it mates perfect with the exhaust so you have no back flow. I believe the japtrix y-pipe is discontinued so they are hard to come around
I wish I had a sound clip but unfortunetly I dont.
Here are pictures of when I first got it built



Current pictures




y-pipe SOLD
Exhaust 500 shipped+ pp fee
450 picked up
Last edited by SA Z-ster; Dec 14, 2010 at 12:50 PM.
Thread
Thread Starter
Forum
Replies
Last Post
StreetStandard
Exhaust-Vendor
11
Jan 12, 2016 03:21 PM




