So I finally put my wheels on yesterday. I think it looks pretty good but I have run into a couple small problems. The fronts did not clear the brakes so I had to put a crappy 7mm spacer on there and that does not leave me much stud to tighten down the lugs as far as they probably should go. So I ordered hubcentric spacers and longer studs. Then on the rear I am rubbing a little bit over bumps so I am going to have to raise the back up about .25" and remove the insulation under the wheel well. After that I will check the camber and try to get it close to spec.

Here you go...

looks clean. nice work.

It looks like the rear wheels stick out too far. I can't tell about the fronts.

That's a nice, aggressive rear, looks great!
-GP-

Fronts are dead flush but the rear could be a few mm less. Not sure there is much else I can do about except get a different set. Does it look bad?

looks good

chad
looks awesome!!!!!
dont raise it at all, maybe lower the front a little more!! just add a littl emore negavtie camber and it will look sick. go see christian at lokey and have him do it, tell him just to camber it in like mine, just not as much.

very nice looks real good

Hey, car looks great man. I am not really that hot on the new g37s but yours in black, on those rims changed my mind. +1 on running the camber on the rear. Keep it up!

nice

very very nice!

Not a fan of black on black but the car looks nice.

looks good

have you thought about blacking out ur headlights?