Greddy TT Kit - 2006 G35 2dr 6 MT
Registered User
Joined: Aug 2006
Posts: 173
Likes: 0
So, is it pretty much a BAD BAD idea to make any attempts at doing this without pulling the engine?
If the answer is yes I can get a lift for like $150.00 so that's not an issue, but would I need to pull the engine all the way out, or just tilt it up and raise it a good foot or so for clear access to the manifolds?
If the answer is yes I can get a lift for like $150.00 so that's not an issue, but would I need to pull the engine all the way out, or just tilt it up and raise it a good foot or so for clear access to the manifolds?
Originally Posted by QuadCam
what are you doing about a bumper? the stovk bumper will be kind of restrictive for that intercooler.
I cut the crap out of my Nismo bumper to allow more air flow.
See the 9th page of this thread. There are two sets of pics.
https://g35driver.com/forums/showthr...=130900&page=9
Originally Posted by MightyMouse
So, is it pretty much a BAD BAD idea to make any attempts at doing this without pulling the engine?
If the answer is yes I can get a lift for like $150.00 so that's not an issue, but would I need to pull the engine all the way out, or just tilt it up and raise it a good foot or so for clear access to the manifolds?
If the answer is yes I can get a lift for like $150.00 so that's not an issue, but would I need to pull the engine all the way out, or just tilt it up and raise it a good foot or so for clear access to the manifolds?
You would need to at least get to the point where the manifolds and turbos can be installed. You don't have to pull the motor all the way but you will need to drop it quite a bit down. One of my turbos is 1/8" from the car so there is no way it could have been installed any other way.
Thread
Thread Starter
Forum
Replies
Last Post
BlackGee35
G35 Coupe V35 2003 - 07
1
Jul 23, 2015 01:36 PM
