**Official Bluebatmobile Vinyl installs thread*** (with installer contact info)
#46
#47
#50
#54
#55
#60
The install of the roof is not an easy one due to how large the piece of vinyl is, and you don't want it to fold over on itself and stick to itself. What i did was pretty simple.
1: I laid it upside down on the dry roof (vinyl down, backing part facing up)
2: I peeled just a 1" section of each corner and used a small piece of packaging tape down on the corner to hold it down
3: once all for corners are taped down, i proceed to remove the backing.
4: as I peeled it back, I sprayed the sticky surface of the vinyl with the soapy water.
5: After the backing is completely off and the vinyl is soaked in the water/soap solution, I then removed the tape from each corner
6: then lift up the vinyl at each section and spray the roof with the soapy water as well. (do not do this part if the backing is still on the vinyl so that no water comes in contact with the backing if the vinyl is attached)
7: flip the vinyl over, and proceed to install it.
1: I laid it upside down on the dry roof (vinyl down, backing part facing up)
2: I peeled just a 1" section of each corner and used a small piece of packaging tape down on the corner to hold it down
3: once all for corners are taped down, i proceed to remove the backing.
4: as I peeled it back, I sprayed the sticky surface of the vinyl with the soapy water.
5: After the backing is completely off and the vinyl is soaked in the water/soap solution, I then removed the tape from each corner
6: then lift up the vinyl at each section and spray the roof with the soapy water as well. (do not do this part if the backing is still on the vinyl so that no water comes in contact with the backing if the vinyl is attached)
7: flip the vinyl over, and proceed to install it.