hahahahaha

anyways, $400 for just installation seems outrageous.
i would look around to see if you can get a better deal.

 

i would do it just measure 2 or 3 times b4 drilling

 

i bought the spoiler and it came with a template and hardwares.. went to this bodyshop and got it installed for $60... they did a PERFECT job.. no complains

 

u buy it off a site if so can u post it Thanks

 

i bought it from chadd(infiniti dealer from cali).. he's in this forum.. bought it as NEW, OEM, factory paint for $445 shipped.. it also came w/ rear under diffuser for the aerodynamics

 

damn you got a deal and a half.. whats his name so i can pm him.. thanks

 

Chad@infinitispecialists

 

Do it your damn self! Spoilers are easy, but you MUST have another person helping you, to hold the spoiler still as you drill. They also serve as another set of eyes to make sure everything is straight. And you can make you own template out of cocktail straws and masking tape. And predrilling is your friend.

 

Why the hell do you need a template. Just mark where you need to drill, and get it done.

 

uhh.. you need to drill around 10 holes in my trunk.. impossible to do it without a template

 

i bought my spoiler off of ebay from som guy i think they call him the wing king. It came out to 149.00 painted and shipped to my door. then i got it put on for 100.00 even by some guy who has been putting on spoilers for a living for 10 yrs now. took under an hour.

 

oh, and it was way too many holes and rubber stuff that he put in my trunk so i wouldnt do it myself if i were you. it hurt to see the guy drilling holes into my trunk lid. but looked way better when done.

 

Most spoilers come with little pieces of plastic that you tape down before you drill.

1: Put the plastic pieces in all of the holes that are in the wing.

2: Place the wing where you want it on the trunk and measure it out to make it even and centered. (you will need another person to hold the wing in place while you adjust it.

3:Tape the plastic pieces to your trunk with masking tape.

4: Remove the wing from the plastic pieces.(you are now left with the plastic pieces taped to your trunk. This is where your holes will be drilled.)

5: Make sure it is where you want it because you will be drilling holes next and you don't want to miss.

6: Use a thin drill bit that will fit down inside the plastic pieces that are taped to your trunk. The plastic pieces will make you drill straight so don't worry about missing your mark.

7: Drill all the holes with the small bit and then remove the plastic pieces.

8: Now you drill the holes again using the bit that is needed for the bolts to fit in nicely.

9: Put the wing on and screw that sucker down.

10: Important part that I'm sure alot of people forget. Spray all the drilled holes with some form of anti rust spray.

You are done the wing install. Now you just have to connect the brake light!

 

i am not gonna even attempt to install it myself.. i am paying someone to do it just now 350

 

Well now I agree with you. If you don't have faith in yourself, then who are we to argue. Pay the man.