i just put the opaque black on my 05 coupe and they look blistered.. Is this how they normally turn out or are they usually very slick and smooth??? I havent tried Andrew yet....Just looking for a quicker answer.

 

How did you apply them?

My overlay says to use soapy water underneath them, then squeegy out the liquid for the best smoothness.

 

I've done 2 of his. Try to get that water out or you can use a slight pin needle to pop it (don't worry you wont see that).

Blow dryer also helps to remove. When I did my fronts those lil bubbles vanished on there own when Mr. Sunshine said hello.

The rears were a lil bit more of a challenge because of the curves

 

from what i've heard your supposed to leave the overlays in the sunlight/heat so they go away...my friend got them done...too bad right wen he did it there was purty mch no sun for like 2mnths...hehehe

 

sounds like you have moisture trapped underneath! Look here at some application guides:

http://www.scionlife.com/forums/viewtopic.php?t=34653

http://www.scionlife.com/forums/viewtopic.php?t=131312

http://auto.badtziscool.com/howtos/overlays.asp

Bat™

 

bat when are the 07 altima overlays goign to be ready and pictured?

 

The more time you give them, the better they turn out.

The worse job you did, the longer your going to have to wait

 

Headlights and signal overlays done . Taillights will be ready after Tuesday .

Bat™