Ok, I was going to post this in electronics and I feel like it doesn't quite fit there, but if it does moderators feel free to move this thread.

Soooooo....to my question. Does anybody know which fuse controls power to my gauge cluster? Thanks.

 

this is what I found in my manual, for an 07

UNIFIED METER CONTROL UNIT

Speedometer, odo/trip meter, tachometer, fuel gauge and water temperature gauge are controlled by the
unified meter control unit, which is built into the combination meter.

Shift-up indicator is adopted in the combination meter (M/T models). Setting of shift-up engine speed
(rpm) can be set with odo/trip meter.

Odo/trip meter and A/T indicator segments can be checked in self-diagnosis mode.

Meters/gauges can be checked in self-diagnosis mode.
POWER SUPPLY AND GROUND CIRCUIT
Power is supplied at all times

through 10A fuse [No. 19, located in the fuse block (J/B)]

to combination meter terminal 21.
With the ignition switch in the ON or START position, power is supplied

through 10A fuse [No. 14, located in the fuse block (J/B)]

to combination meter terminals 22 and 23.
With the ignition switch in the ACC or ON position, power is supplied

through 10A fuse [No. 6, located in the fuse block (J/B)]

to combination meter terminal 18.
Ground is supplied

to combination meter terminals 1, 24 and 25

through grounds M30 and M66.