I was rading another post where it talks about unscrewing like 15screws, then sliding plates around to get at it; so, out of curiousity

1) Is it really hard to do? (i.e., on the mustang it was easy- slide underneath, twist the filter, drain, apply new one)

2) Is it gona be necessary to buy an electric screwdriver for convenience?

www.ironpumping.com
^^Bodybuilding Made Simple

 

Yeh man it's easy. Not as easy as other cars, but they don't have the same cover to take off, or limited ground clearance necessitating ramps.
I have time, have a garage and tools, and enjoy doing the job. You must decide for yourself[img]/w3timages/icons/smile.gif[/img] good luck.

<font color=red>Gsedanman</font color=red>

 

when you slide under the car you'll see the under cover panel and about 22 screws. You only need to take off 7 of them and the panel will drop down.

I rather do it myself, gives you that assurance it was done right, nothing missing and nothing swapped.

BS G35C 6spd navi/aero/prem

 

Hey, I havven't done this yet, but which 7 screws?

 

sorry I didn't take pictures. If you look at the whole bottom cover, you'll see a crease right before it connects to the front bumper cover.

Just take off enough screws so the cover just folds down.
I'm too lazy right now but tomorrow I'll grab a flash light and take a look.

BS G35C 6spd navi/aero/prem