this shark on the roof

[/QUOTE]

I am afraid that there can be some traces or holes ! what i need to do
thanks guys

 

razor blade..unless youre talking about the shark fin then

 

what shi.t are u talking about? shark fin?? or the numbers???

 

roof

 

just rip it up or run some fishing line along the bottom. it's going to leave some adhesive so you'll have some clean up afterwards.

 

It might be magnetic. The mini one I have on my trunklid is only held on by a very strong magnet. It'll lift right off, but be careful not to slide it as it will scratch your paint.

 

If its got adhesive under it, go to any automotive store and get some goo gone... Leave it on there for 3 mins and itll wipe off so easy... What i used when debadging mine...

 

wd40, blow dryer, fishing line, and goo gone.... in that order...

spray wd40 let sit for 10 min... heat up with blow dryer, use fishing line.. then use goo gone to remove any leftover glue... follow by a wax

 

if you're still going to keep the satellite radio and want the actual shark fin, check out my DIY: https://g35driver.com/forums/audio-video-electronics-diy/194889-diy-satellite-shark-fin-install-headliner-removal.html

 

I'm living in Russia and the satallite radio doesn't work here-so I don't need it

 

^this shows the fin with wire going through the roof so there is a hole in it.

On SEGAS pictures wire is on top of the roof and goes in to the car between the rear glass and the roof.

So it's either magnetic or taped.

 

I just took the same one off my roof last week. It's on with adhesive and magnets.

 

fishing wire

 

what about the wire.

How did you get rid of that?

Did you just cut it off by the rear window or did you cut it somewhere inside and pulled it out?

 

It runs along the weather stripping on the outside of the back window. All you have to do is pull it out from under the weather seal.