how to remove this sht
#17
#21
Originally Posted by S E G A
do you know where does this wire goes?
#22
Originally Posted by Bigd2k6
the wire goes along the weather stripping on the left side of the back window. if installed per the factory instructions, it will route over the body seal of the trunk and tuck into the "carpet". from there it will go to the lower left of the spare tire (if looking straight down at it) where the oem satellite radio tuner goes. if you need a pic, let me know, i'll post one up.
#24
Hot day + Hair Dryer + Fishing Line + WD40 = GONE
On a warmer day, break out an extension cord and put the hair dryer on high heat. Focus it on the BASE of the shark fin (of course) and it will eventually start to loosen. Grab your fishing line and wrap some around your left hand and some around your right hand making a stiff line (like you are going to floss some really giant teeth or just sneak up on someone to choke them to death, lol) and start from the top of the shark (furthest away from you) and work the line going back-and-forth (left to right - right to left) at the base of the shark going TOWARDS YOU (the trunk of the coupe).
Repeat these steps until it's completely removed.
Use the WD40 to get the adhesive off (WD40 will dissolve the adhesive).
WAX the crap out of the roof and call it a day!
Hope this helps.
Thanks Guys!
-WoW
On a warmer day, break out an extension cord and put the hair dryer on high heat. Focus it on the BASE of the shark fin (of course) and it will eventually start to loosen. Grab your fishing line and wrap some around your left hand and some around your right hand making a stiff line (like you are going to floss some really giant teeth or just sneak up on someone to choke them to death, lol) and start from the top of the shark (furthest away from you) and work the line going back-and-forth (left to right - right to left) at the base of the shark going TOWARDS YOU (the trunk of the coupe).
Repeat these steps until it's completely removed.
Use the WD40 to get the adhesive off (WD40 will dissolve the adhesive).
WAX the crap out of the roof and call it a day!
Hope this helps.
Thanks Guys!
-WoW
#25
Originally Posted by WhiteonWheat
Hot day + Hair Dryer + Fishing Line + WD40 = GONE
On a warmer day, break out an extension cord and put the hair dryer on high heat. Focus it on the BASE of the shark fin (of course) and it will eventually start to loosen. Grab your fishing line and wrap some around your left hand and some around your right hand making a stiff line (like you are going to floss some really giant teeth or just sneak up on someone to choke them to death, lol) and start from the top of the shark (furthest away from you) and work the line going back-and-forth (left to right - right to left) at the base of the shark going TOWARDS YOU (the trunk of the coupe).
Repeat these steps until it's completely removed.
Use the WD40 to get the adhesive off (WD40 will dissolve the adhesive).
WAX the crap out of the roof and call it a day!
Hope this helps.
Thanks Guys!
-WoW
On a warmer day, break out an extension cord and put the hair dryer on high heat. Focus it on the BASE of the shark fin (of course) and it will eventually start to loosen. Grab your fishing line and wrap some around your left hand and some around your right hand making a stiff line (like you are going to floss some really giant teeth or just sneak up on someone to choke them to death, lol) and start from the top of the shark (furthest away from you) and work the line going back-and-forth (left to right - right to left) at the base of the shark going TOWARDS YOU (the trunk of the coupe).
Repeat these steps until it's completely removed.
Use the WD40 to get the adhesive off (WD40 will dissolve the adhesive).
WAX the crap out of the roof and call it a day!
Hope this helps.
Thanks Guys!
-WoW
#26
#27
Thread
Thread Starter
Forum
Replies
Last Post
RemmyZero
V36 DIY
10
04-23-2018 11:13 AM
FS[NorWest]: 04 OEM Faceplate and CD/Tape Unit
Oregon13
Audio/Video/Electronics
5
03-01-2016 12:06 AM