Invidia Gemini Exhaust installed... Tips stick out too far?
My Tips ended up the same way... I'm planning on getting under there and putting the Dremel Metal cutting disc to the pipes..
I'm going to look into the left over welds like the other guy mentioned
I'm going to look into the left over welds like the other guy mentioned
YEA I have the rolled burnt tips... Wonder if there's a difference in the inside
Registered User
Joined: Feb 2010
Posts: 394
Likes: 7
From: Boston Metro West
Athens Blue G35 Coupe 6MT
PICS!! Definitely were too long before, need to see how they sit now!
My ROLLED TITANIUM Tips
**BEFORE**
**THE REASON**
The inside of the Rivots is whats preventing the tips from sliding further back. Here is an inside view.
**THE FIX**
The passenger side only took a little bit of muscle to get the tip's rivots past the edge of the pipes.
The Driver side for me took alittle bit more work... I just simply took my dremel and grinded the contact side of the rivots down to a slight angle just to clear the pipes edges a bit easier.
**RESULT**
**THE REASON**
The inside of the Rivots is whats preventing the tips from sliding further back. Here is an inside view.
**THE FIX**
The passenger side only took a little bit of muscle to get the tip's rivots past the edge of the pipes.
The Driver side for me took alittle bit more work... I just simply took my dremel and grinded the contact side of the rivots down to a slight angle just to clear the pipes edges a bit easier.
**RESULT**
Last edited by ZEROSIX_project; Apr 15, 2012 at 02:21 PM.
Thread
Thread Starter
Forum
Replies
Last Post
