hey guys im about to purchase some enkei rp03's today but it need to know it they'll fit first

19x8.5 and 19x9.5 Enkei RP03s with +22 offset all around

will it fit my 03 coupe with factory brembos?

and does anyone know how flush it will sit by chance?

 

wont sit flush by far, you need 10 in the front and 10.5 to sit flush with that offset.

 

Should clear brembo

 

so if i want it to sit flush what spacers should i use all around about 10mm?

 

no you need more than 25 to make it sit flush, and anything after 25 is not safe... soo get a wider wheel kthx.

 

Flush or hella flush?

If they were my wheels, 20mm spacers front and rear.

But if you want them to just look good then 15mm will work.

Jackus, a 30mm spacer on that is going to poke....

 

and without spacers how bad will it look?


i mean i dont want my wheels sticking out i just want them flush, i also dont want them sunken in too bad, but will it be worse then stock?

 

Are you lowered yet?

 

not lowered, sounds like im going to have to go with a different wheel

 

Im slightly poking with 9.5/10.5 +17/+24

 

Na man, you'll be fine with those wheels.

Do you plan on going lower? Every inch you lower your car basically subtract 8-10mm from your offset.

I suggest you go lower, but I tell everyone that.

 

Im guessing your not lowered

 

not lowered, i really want these wheels but i'm afraid it will look bad on a stock ride setup without spacers :/

 

He's not lowered and I just looked at photos of his car, he's not poking.

You don't understand offsets very well.... In the thread where you shower of your car and you dad gfs car, someone immediately told you, drop and spacers.

OP buy some spacers, nothing wrong with em.

 

so instead o a spacer i could go for a 1-2" drop and not run spacers and i will sit flush?

thats cool, i never really knew that thanks for the info!