Traction Rod & Camber Arm help decide (I have done my research)
#1
Join Date: Jul 2009
Posts: 235
Likes: 0
Received 0 Likes
on
0 Posts
Traction Rod & Camber Arm help decide (I have done my research)
In my previous thread I had stated that both my camber arm and my traction rod were bent on my rear passenger side and needed to be replaced. So I have decided to go with ichiba camber arms with toe bolts.
The only problem I have is deciding which traction rod (traction arm) to go with since I have been reading here that adjustability (although i will not be adjusting it just need a replacement since mins is bent) of the traction rod with mess up the geometry and the caster of the rear upper and lower mount of the rear. Im going for the aggressive streched look some time in the future.
Ps: car is stock height right now
The only problem I have is deciding which traction rod (traction arm) to go with since I have been reading here that adjustability (although i will not be adjusting it just need a replacement since mins is bent) of the traction rod with mess up the geometry and the caster of the rear upper and lower mount of the rear. Im going for the aggressive streched look some time in the future.
Ps: car is stock height right now
Thread
Thread Starter
Forum
Replies
Last Post
Z1Motorsports
Suspension-Vendor
56
05-31-2020 01:56 PM
2_Liter_Turbo
Brakes & Suspension
18
01-19-2018 01:48 AM
StreetStandard
Suspension-Vendor
9
01-18-2016 03:36 PM
netcbc
Steering & Suspension CDN
0
07-24-2015 01:59 PM