Finish installing stillen/z-tube. Does it look right? (PICS) - Page 2 - G35Driver

Dec 4, 2010 | 01:01 PM

#16

DrewLe

Registered User

iTrader: (14)

Joined: Jul 2010

Posts: 2,886

Likes: 40

From: Reppin' FL in DFW

That's it. You can't physically move the AC line. To protect it, just wrap some foamy packaging material around it, that's what I did.

Dec 4, 2010 | 04:58 PM

#17

cHink

Thread Starter

Registered User

Joined: Nov 2010

Posts: 53

Likes: 0

what kind of foamy package you use?

Dec 4, 2010 | 09:18 PM

#18

DrewLe

Registered User

iTrader: (14)

Joined: Jul 2010

Posts: 2,886

Likes: 40

From: Reppin' FL in DFW

It's like the foamy packaging material that comes in rolls or sheets.

But essentially, you can wrap anything around the AC line to act as a barrier between the z-tube, AC line, and engine bay.

Dec 4, 2010 | 09:28 PM

#19

Project

Registered User

iTrader: (30)

Joined: May 2008

Posts: 6,809

Likes: 31

From: SOVA....PA & NJ

Goto home depot and go into the plumbing section. They have foam tubes that protect the water lines in a house in different sizes. Just get a close fit and your good to go.

Dec 11, 2010 | 04:03 PM

#20

bulletproofpat

Registered User

iTrader: (2)

Joined: Mar 2009

Posts: 93

Likes: 0

Looks good to me. So much better than the stock setup.

Nov 1, 2011 | 12:58 PM

#21

thepro78

Registered User

Joined: Oct 2011

Posts: 215

Likes: 1

Quote:

Originally Posted by *****

Uhm i just took off the ECU(not unscrewing the screws) i was trying to hard to take it off but i finally took off the plug. I didnt unplug the Negative battery, will anything go wrong?

So here is the picture that i just finish installing a few minutes ago and i think it looks right. Tell me if anything is wrong with it. I had a hard time of figuring out which way is the Z-tube cause the stock G-Tube hose is pointing up and tryna figure out which way does the Z-tube hose faces.

im not sure if this is the ac line you guys want to protect but this is a picture i took this morning and it is very close to my tube. I have read the JWT Pop Charger thread about protecting the AC Line but i tried to move it and it doesnt even move.

where did you get the heatshiled// intake box for this? does it come included with the ztube kit or is it an extra part