Uhm i just took off the ECU(not unscrewing the screws) i was trying to hard to take it off but i finally took off the plug. I didnt unplug the Negative battery, will anything go wrong?

So here is the picture that i just finish installing a few minutes ago and i think it looks right. Tell me if anything is wrong with it. I had a hard time of figuring out which way is the Z-tube cause the stock G-Tube hose is pointing up and tryna figure out which way does the Z-tube hose faces.







im not sure if this is the ac line you guys want to protect but this is a picture i took this morning and it is very close to my tube. I have read the JWT Pop Charger thread about protecting the AC Line but i tried to move it and it doesnt even move.

 

Install looks good to me... Ztube hose will face down and that's fine. I would have just unplugged the battery for a reset though. Anyways you should be ok as per the pics.

 

Looks good! Just make sure that your tube is not rubbing on you ac line.

 

Looks okay to me (I have one too)

 

dont mess with the ecu plz.....and you're supposed to disconnect the battery to be on the safe side.

 

what site did u uploade the pics on?

 

my bro is getting me a intake for xmas and reading some comments Do i have to disconnect the battery??

 

looks good to me.

 

Why does the battery need to be disconected??? Im confused!?!?!?!?

 

^ idk.. i just took off the ECU without disconnecting my negative battery.

i dont understand. The ztube and the G-tube is just the same except Z-tube dont got the air chamber. Its like the same set up. But u got any pics of how the ac line and ztube suppose to look like so that its not rubbing?

 

^ Check this thread

https://g35driver.com/forums/intake-...e-ac-line.html

 

It's a way to reset the ECU after the install

 

Lookin good, but you can always do the pedal ecu reset so you don't have to reset everything.

 

You have two holes in the top of the Stillen cover, you can buy a couple push pens (Nissan) to cover those holes. Can't wait for ****** next post....
Gary

 

^ thanks gary, i will look for that when i have time

im not sure if this is the ac line you guys want to protect but this is a picture i took this morning and it is very close to my tube. I have read the JWT Pop Charger thread about protecting the AC Line but i tried to move it and it doesnt even move.