Car stalls at high RPMs after ztube and pop charger install
#1
Car stalls at high RPMs after ztube and pop charger install
installed the ztube and pop charger by the write up on here. reset the ecu and the idle. car drives fine but when i get on the car and let the car get into the upper rmps 4500-redline through a couple gears(example me passing someone). once i push in the clutch and put the car in neutral to coast the car kills.. it has done this 3 times since the install and i checked everything all the connections and everythings fine. dont know what to do next..
#2
#8
my350z has covered this problem several times.
1. make sure everything is tight.
2. clean the maf sensor.
3. clean the throttle body.
4. they say to simply stop putting it in neutral - doesn't save a considerable amount of gas, and not nearly as safe while braking compared to being in gear.
1. make sure everything is tight.
2. clean the maf sensor.
3. clean the throttle body.
4. they say to simply stop putting it in neutral - doesn't save a considerable amount of gas, and not nearly as safe while braking compared to being in gear.
#9
Registered User
iTrader: (4)
my350z has covered this problem several times.
1. make sure everything is tight.
2. clean the maf sensor.
3. clean the throttle body.
4. they say to simply stop putting it in neutral - doesn't save a considerable amount of gas, and not nearly as safe while braking compared to being in gear.
1. make sure everything is tight.
2. clean the maf sensor.
3. clean the throttle body.
4. they say to simply stop putting it in neutral - doesn't save a considerable amount of gas, and not nearly as safe while braking compared to being in gear.
I opt for cleaning the MAF and or relearn idle air via consult.
#12
no i did not disconnect the battery i just reset the ecu and idle after the install. i will try cleaning the MAF also. thanks alot guys
#13
Registered User
iTrader: (10)
Gary
#14
also ive noticed that if i get into the higher rpms the needle drops very quickly and all the way down to 500 then jusmps around a little until it gets settled around 700 or so..
Last edited by blackx07; 06-28-2011 at 04:04 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Tolboothwilley™
Exterior-Vendor
6
07-28-2016 12:42 AM
beevanhuynh
Audio, Video & Electronics
1
07-14-2015 09:06 AM