Ok, so I want to try and align my center console(left side is not even) so I put car in N
popped off the console then found there was not much I could do to align it. So I put it all back to together. At the same time I figure I would unplug the battery to reset ECU(if it really works) So get everything back together, take it for a spin to make for it everything is good. all is good until I get back...

I turn off the car and it starts beeping at me. Then I get out of the car and it beeps like I left the keys in the car. After it is done it all stops, until I try and lock the doors then it beeps again.

So now when I am sitting in car and turn to ACC and back to off it starts beeping at me again then the rapid beeps when I open and close the door.

Ideas anyone? Also never tried or noticed before but should you be able to shift out of P when the car is off?

Seems like my shift lock is engaged or something.

sorry for the long post. Thanks for any help.

 

Did you mess with the cables on the left side of the shift assembly?

 

No, just sat it on its side on the passenger seat with all the cables connected.
Then put it back in place.

 

Figured it out.

When I put the shift **** back on it must have been down to far, car was thinking the
car was trying to be shifted out of P. I have the MOMO shifter so the button is on the top.

Did not notice it last night when it was darker but the car was not fully in the LOCK 0 postion.