Homemade invisichord for $2
#1
Homemade invisichord for $2
Made this a few days ago, thought I'd share with anyone who feels like doing a small cheap mod for their detector. I got the cable from an electronic supply warehouse (MRO) but I'm sure you can get these anywhere. Just a standard 4 pin connector.
I also wrapped mine in black heatshrink to hide the cable better, and soldered legs from a massive capacitor on the ends of the wires to act as prongs to mock the invisichord. Holds on solid, no contact issues either.
For mine, the black/red on the cable were ground and the yellow/green were hot. I just probed the charger with a multimeter to find that out. I'm sure it's the same on most detectors but instead of potentially frying your $300 toy, take ten seconds to confirm it.
Now I just need to make a custom mount and I'll be satisfied.
I also wrapped mine in black heatshrink to hide the cable better, and soldered legs from a massive capacitor on the ends of the wires to act as prongs to mock the invisichord. Holds on solid, no contact issues either.
For mine, the black/red on the cable were ground and the yellow/green were hot. I just probed the charger with a multimeter to find that out. I'm sure it's the same on most detectors but instead of potentially frying your $300 toy, take ten seconds to confirm it.
Now I just need to make a custom mount and I'll be satisfied.
The following users liked this post:
seymore4 (09-04-2012)
#7
Trending Topics
#8
#10
Thread
Thread Starter
Forum
Replies
Last Post
sykoenigma
Intake & Exhaust
10
01-19-2011 10:55 AM