G35 Coupe V35 2003 - 07 Discussion about the 1st Generation V35 G35 Coupe

Slip, ses, and vdc off lights all on

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old Jul 27, 2015 | 09:52 AM
  #1  
Wayne9011's Avatar
Thread Starter
|
Registered User
Joined: Jul 2015
Posts: 3
Likes: 0
Slip, ses, and vdc off lights all on

I drive a 6mt 06 g35 coupe.

So I was sitting in the McDonald's parking lot and my car just stalled while in neutral. So I just started it back up and it was perfectly fine and I drove home. About 4 hours later I got back in it, when to start it, and it took longer than normal. When it finally did start, it made a loud, high pitched screeching noise. Sounded like a belt. And the vdc off, ses, and slip lights all came on. I drove it to work today, it runs fine. Just the lights on are and it takes an extra second or 2 to start. Any ideas?
 
Reply
Old Jul 27, 2015 | 10:10 AM
  #2  
VenomGT9's Avatar
Registered User
iTrader: (2)
Joined: Mar 2013
Posts: 1,633
Likes: 130
From: Chicago
Check all fluids before driving again and then troubleshoot
 
Reply
Old Jul 28, 2015 | 02:57 PM
  #3  
Blue Dream's Avatar
I drove ttrank's car solo
iTrader: (50)
Joined: Mar 2009
Posts: 18,299
Likes: 1,488
From: By the sea, Tx
G35 sedan w/ too much money in mods
Premier Member

Possibly your camshaft position sensors and/or your crankshaft sensor are starting to go out. Take to an auto parts store and see if you have any codes pop up.
 
Reply
Old Aug 1, 2015 | 04:38 PM
  #4  
dave's Avatar
Registered User
Joined: Oct 2003
Posts: 884
Likes: 3
From: Virginia
Check your brake fluid.
 
Reply
Old Aug 4, 2015 | 07:38 AM
  #5  
driftsucky's Avatar
Registered User
Joined: Dec 2008
Posts: 1,985
Likes: 156
From: Rochester NY
Go drifting. ¯\_(ツ)_/¯
 
Reply
Old Aug 17, 2015 | 12:08 AM
  #6  
maximino's Avatar
Registered User
Joined: Aug 2015
Posts: 5
Likes: 0
I had this issue as well..I was sitting at a office max on idle and my car just shut off on its own...it was cranking but not turning over..after awhile I got it to start and tried to make it home without idling...I let it sit over nite to see if it was going to do it again and the same lights you say are on was on my dash to..I winded up changing the cam and crank sensors and haven't had an issue since... it's not hard just a bit of a tight spot to get bolts off..but hope if you didn't get it fixed yet that this helps
 
Reply
Old Aug 17, 2015 | 01:24 AM
  #7  
jbelf23's Avatar
Registered User
Joined: Apr 2015
Posts: 7
Likes: 0
From: Long Island
Check cam and crank sensors. Also check brake fluid and break pads. Its usally the brake fluid level. I had this same problem but mine was actually a sensor called a yaw sensor witch is in the door panal i think. Im not 100% sure but i think some guys take it out or turn it off when going to the track
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Hasanbaloch
Engine, Drivetrain & Forced-Induction
15
Feb 29, 2024 08:45 PM
Mry
General Tech Questions
20
Mar 3, 2023 01:03 AM
03sedang35
Engine, Drivetrain & Forced-Induction
1
Aug 29, 2015 07:56 PM
JermaineSanders
New Members Check In
1
Aug 18, 2015 08:57 PM
Wayne9011
Engine, Drivetrain & Forced-Induction
2
Jul 27, 2015 11:25 AM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -4. The time now is 08:10 AM.