Crank No start after putting a first generation (clutch fan) DE into my coupe (05 MT)
#1
Crank No start after putting a first generation (clutch fan) DE into my coupe (05 MT)
So I just finished swapping the motor from an 03 5AT Sedan (confirmed running and it ran like an dream) into my car and i’m having an issue with starting. I’ve replaced the crank sensor, cam sensors, checked grounds that i know of, Checked all plugs, flywheel is aligned, it’s getting fuel and air however it’s not getting spark. I have an Uprev tuned DE ECU that has NATS disabled so i’ve crossed that off the list, i’ve also confirmed the ECU works still by plugging it into my buddies car with virtually the same build except for it being an 04 motor not 03. I previously had swapped this car with a DE and it ran amazing until i spun a bearing again. Coils and Sparks were brand new, ran out of ideas at this point.
Thread
Thread Starter
Forum
Replies
Last Post
Walgreens
G35 Coupe V35 2003 - 07
1
09-02-2022 10:19 AM
Sharpshooter23
Engine, Drivetrain & Forced-Induction
8
10-17-2017 08:48 PM
Acp1986
Engine, Drivetrain & Forced-Induction
1
09-21-2017 01:52 PM