Plastic Push Rivets / Clips - Where Can I order Them ?
Joined: Dec 2004
Posts: 427
Likes: 0
From: SoCal (high desert)
Plastic Push Rivets / Clips - Where Can I order Them ?
You know the ones.
They hold the battery cover on
The front part of the air intake
all the plastic shell pieces of the fender wells, etc
Anyone know the part number ? Proper Description ?
an Online Vendor that sells them ???
They hold the battery cover on
The front part of the air intake
all the plastic shell pieces of the fender wells, etc
Anyone know the part number ? Proper Description ?
an Online Vendor that sells them ???
Joined: Dec 2004
Posts: 427
Likes: 0
From: SoCal (high desert)
Ok I found them at www.everythingnissan.com
Listed in the body section, in some sections it is called a clip, some a pin
Collision Catalog - 2004 - Infiniti - G35 Grille, Grille and components, Grille assy, Pin, Pin
They are 56 cents each (I ordered 50 so that how ever long it takes to get them, I will have enough
)
Listed in the body section, in some sections it is called a clip, some a pin
Collision Catalog - 2004 - Infiniti - G35 Grille, Grille and components, Grille assy, Pin, Pin
They are 56 cents each (I ordered 50 so that how ever long it takes to get them, I will have enough
)
Originally Posted by Sickone
Ok I found them at www.everythingnissan.com
Listed in the body section, in some sections it is called a clip, some a pin
Collision Catalog - 2004 - Infiniti - G35 Grille, Grille and components, Grille assy, Pin, Pin
They are 56 cents each (I ordered 50 so that how ever long it takes to get them, I will have enough
)
Listed in the body section, in some sections it is called a clip, some a pin
Collision Catalog - 2004 - Infiniti - G35 Grille, Grille and components, Grille assy, Pin, Pin
They are 56 cents each (I ordered 50 so that how ever long it takes to get them, I will have enough
)Joined: Dec 2004
Posts: 427
Likes: 0
From: SoCal (high desert)
I assure there are a lot more than 50 on the car, like a dozen per wheel well so thats almost 50, then all the stuff in the engine compartment (a bunch more in the lower plastic covers oif the engine) the trunk, etc
I need some for my right hand battery cover that's on the way
some to properly attach the center air section of the Intake soit doesn't bow up in the middle, some to have as spares cause some areas (like the wheel wells) get dirty and then tend to break when removing them.
I need some for my right hand battery cover that's on the way
some to properly attach the center air section of the Intake soit doesn't bow up in the middle, some to have as spares cause some areas (like the wheel wells) get dirty and then tend to break when removing them.
Trending Topics
Originally Posted by jruss9819
50? That's probably as many are on the whole car.
Our Gs are practically held together by these damn clips!! The whole car is like a lego set, things just snap on and off
sickone,
50 clips - always planning ahead. Good thinking, when I installed my GG 10 wire kit, all of the old ones didn't want to go back on. You can always sell them on Ebay for $1.50 a piece (j/k).
50 clips - always planning ahead. Good thinking, when I installed my GG 10 wire kit, all of the old ones didn't want to go back on. You can always sell them on Ebay for $1.50 a piece (j/k).
Joined: Dec 2004
Posts: 427
Likes: 0
From: SoCal (high desert)
Hey ya Keith,
I never have trouble with the ones up top. they stay clean, if you take them off correctly they are fine....
ebay.... oh man... I am trying to sell off some of my old electronic equipment there right now.
You may be interested.... I have all of my sound damping/deading products and am thinking about tearing in any minute....
The full Monty, remove the front seats, pull the side panels and carpet, and lay down the Sound damper and the absorbing mat....
While I have stuff out I will likely see if I can relieve the seat controls a bit to make it a little less of a pain.
I never have trouble with the ones up top. they stay clean, if you take them off correctly they are fine....
ebay.... oh man... I am trying to sell off some of my old electronic equipment there right now.
You may be interested.... I have all of my sound damping/deading products and am thinking about tearing in any minute....
The full Monty, remove the front seats, pull the side panels and carpet, and lay down the Sound damper and the absorbing mat....
While I have stuff out I will likely see if I can relieve the seat controls a bit to make it a little less of a pain.
Clips
Can't help with the part numbers but I this outfit is the biggest I've ever found and has always had whatever I needed for several Nissan vehicles.
http://www.northlandfasteners.biz/index.html
http://www.northlandfasteners.biz/index.html


