Plastic Push Rivets / Clips - Where Can I order Them ?

Subscribe
Apr 8, 2005 | 12:32 AM
  #1  
You know the ones.
They hold the battery cover on
The front part of the air intake
all the plastic shell pieces of the fender wells, etc

Anyone know the part number ? Proper Description ?
an Online Vendor that sells them ???
Reply 0
Apr 8, 2005 | 01:17 AM
  #2  
bump +1 I want to know too.
Reply 0
Apr 8, 2005 | 02:16 AM
  #3  
Ok I found them at www.everythingnissan.com

Listed in the body section, in some sections it is called a clip, some a pin

Collision Catalog - 2004 - Infiniti - G35 Grille, Grille and components, Grille assy, Pin, Pin

They are 56 cents each (I ordered 50 so that how ever long it takes to get them, I will have enough )
Reply 0
Apr 8, 2005 | 02:19 AM
  #4  
do what I did, took a couple off places that would not affect safety on the loaner for spare parts! Shhhhhh don't tell!
Reply 0
Apr 8, 2005 | 09:51 AM
  #5  
hehehehehh

we'll just call that "parts recycling" G35SanDiego....

already have 50 on the way (well ordered)

I am not in a big hurry
Reply 0
Apr 8, 2005 | 10:28 AM
  #6  
Quote: Ok I found them at www.everythingnissan.com

Listed in the body section, in some sections it is called a clip, some a pin

Collision Catalog - 2004 - Infiniti - G35 Grille, Grille and components, Grille assy, Pin, Pin

They are 56 cents each (I ordered 50 so that how ever long it takes to get them, I will have enough )
50? That's probably as many are on the whole car.
Reply 0
Apr 8, 2005 | 11:08 AM
  #7  
I assure there are a lot more than 50 on the car, like a dozen per wheel well so thats almost 50, then all the stuff in the engine compartment (a bunch more in the lower plastic covers oif the engine) the trunk, etc

I need some for my right hand battery cover that's on the way
some to properly attach the center air section of the Intake soit doesn't bow up in the middle, some to have as spares cause some areas (like the wheel wells) get dirty and then tend to break when removing them.
Reply 0
Apr 8, 2005 | 01:55 PM
  #8  
Quote: 50? That's probably as many are on the whole car.
You've apparently not started to take apart this car
Our Gs are practically held together by these damn clips!! The whole car is like a lego set, things just snap on and off
Reply 0
Apr 8, 2005 | 02:39 PM
  #9  
sickone,

50 clips - always planning ahead. Good thinking, when I installed my GG 10 wire kit, all of the old ones didn't want to go back on. You can always sell them on Ebay for $1.50 a piece (j/k).
Reply 0
Apr 8, 2005 | 06:07 PM
  #10  
Hey ya Keith,

I never have trouble with the ones up top. they stay clean, if you take them off correctly they are fine....

ebay.... oh man... I am trying to sell off some of my old electronic equipment there right now.

You may be interested.... I have all of my sound damping/deading products and am thinking about tearing in any minute....

The full Monty, remove the front seats, pull the side panels and carpet, and lay down the Sound damper and the absorbing mat....

While I have stuff out I will likely see if I can relieve the seat controls a bit to make it a little less of a pain.
Reply 0
Apr 8, 2005 | 09:10 PM
  #11  
Clips
Can't help with the part numbers but I this outfit is the biggest I've ever found and has always had whatever I needed for several Nissan vehicles.

http://www.northlandfasteners.biz/index.html
Reply 0
Apr 8, 2005 | 10:30 PM
  #12  
Nissan reffers to them as a Clip the part number is 0155309321 or
01553-09321 Which is what is on the pack
Reply 0
Oct 21, 2013 | 03:51 PM
  #13  
are these clips what hold the grill and front bumper together?? because my front bumper was rear ended and the force broke the clips and now i have no grill on my car.
Reply 0
Oct 21, 2013 | 11:28 PM
  #14  
Infiniti parts USA has them for 10 cents each I ordered 50 also. total was $15 shipped
Reply 0
Oct 21, 2013 | 11:48 PM
  #15  
What you're looking for are Nissan clip trim #01553-09321 available at any Nissan/Infiniti dealership. I have 3 left in my package, time to order more....Gary
Reply 0