ladder dented car....fawk!!!(pics)
#16
Registered User
iTrader: (1)
Join Date: Mar 2005
Location: Austin, TX, USA
Posts: 309
Likes: 0
Received 0 Likes
on
0 Posts
yeah, I'm in body industry too....I think it can be PDR'd....It may not come out perfect due to the curve, but a good PDR tech can get it looking much better.....probably $150-200 at the most for PDR....they'll have to remove the tail lamp...good luck...update the thread with pics after you get it done....
#18
#19
I had the same thing happen with my last car: my Black & Decker workbench fell across the left-rear quarter panel and put a two-inch vertical crease across the so-called "character line." I rubbed it out from inside the panel as best I could, but I could never get the horizontal line smoothed out properly. Then again, I'm a complete amateur. I just lived with it.
I feel your pain, man.
I feel your pain, man.
Thread
Thread Starter
Forum
Replies
Last Post
FS[NorEast]: New OEM G35x Compression Rods - Save!!
The Fixer
Steering & Suspension
15
11-01-2015 03:26 PM