Would like to know which front camber kit to use on my G35 sedan thats been lowered with 350z spring/front and coupe spring/rear.

 

yep. They couldn't get one tire back into stock specifications.

 

I had 350Z H-Techs on my 03 sedan with no camber kit front or rear. The rear was out of spec, but not anything ridiculous. The front had no issues. I am surprised you need a camber kit up front with those springs which drop the car about an inch. My car was dropped about an inch and a half with the H-Techs. I say take it somewhere else to get aligned.

 

If you need one I would get the SPC. I have had their products on my last four cars and been very happy. I have the SPC rear camber arms and toe bolts at my house but have not installed them yet. Have not coughed up the money for the fronts for this car yet. Stillen is good but expensive. Stay away from Kinetix, one guy recently had a rear arm snap and caused him to total his G.

 

^^yeah i read about that in the coupe forum...sucks

 

I have seen that post and I am going to stay away. Did you install the spacers on your tower?? How hard is to put the spacers in. I read a post where someone didn't install them.

 

I don't have the SPC kit on my G, just on my last few cars. There is a install thread around here somewhere with good details.

 

If you have money burning a hole in your wallet and you can actualy find a pair, 350Evo is the way to go hands down. Otherwise the SPC or SPL will work fine for your needs.

 

Yep the 350Evo have been discontinued and they were going for $900 fro the pair. I think Stillen is about equal to 350Evo's because they cost almost the same.

If you don't install the tower spacer on the SPC, how much positive camber adjustment will you be able to get.

 

Looks like I spoke too soon. Some people are reporting problems with the SPC front kit that just came out.

 

Yep.I think the problem is with the spacer being used although. So now I am going to look at getting SPL Part front camber kit if I need them.

 

How far out of spec is it? A little extra negative camber is a good thing. Unless a little less tread life will get at you .

 

Right front is at -1.2