now i can roll my windows up and down with my remote.

 

was the install difficult?

 

http://www.boostedconcepts.com/kptech.html

50 bucks shipped.. not bad!

might order this

how was the install?

 

i have this module but for my 03 Accord coupe and it works great. Does this one(1) unit control all four(4) windows or you have to buy another for the back?

 

Cheaper than a smart key.

 

Ive always been able to roll them down, just cant roll them up. 50$ not bad

 

I have had one of these for a while. Kevin makes awesome stuff.

 

havent installed yet. kinda of wet around here for last few days now. hopefully the weather will clear up by the end of the week.

 

It's an easy install. Just have to pull the door panel. Took me about 20 minutes.

 

kp makes goo dstuff! had mine in for a while now and it comes in handy in this 90 degree weather over here. i used it twice today!

 

pretty straight forward insturctions. so simple!

 

I have a question....

1. Does this work on 06 G's?

2. Instead of using the remote, can this be used with the little black rubber button on the door? (Intelligent Key)

3. Is this for all windows or just one window?

4. If it is all windows, is the install only in one door or ALL doors?

Thanks

 

Send these to KP to be 100% sure.

 

Should work on all '06s without an issue.

It works off of door lock actuator pulses, so if by pushing the little black button on the door locks the door EVERY time you push it then it will trigger the module (you can also trigger the module from the inside 'lock' button IF the ignition is switched off).

One module will control all anti pinch protected windows. To quickly find out if you have 4 anti pinch windows lower all four windows then insert your key in the drivers door key cylinder and turn and hold it in the 'LOCK' position for a few seconds. If all four windows raise then you have anti pinch on all four, if only the front two raise then you only have it on the front two. Pre '06 you had to have the premium package to have anti pinch on the back windows.

It is one module that installs in the drivers door only. It sends a low current comm signal to the BCM to request that it raise the windows. The module is completely low current and will draw less then 20mA when raising the windows.