I have been thinking about trying to pull of a coupe front end swap. there'll probably be some blending/combining of panels to make the fenders work with the sedan doors, A-pillars and such, but I am wondering if most of the front end (hood, bumper, head lights, etc) will bolt right up or do you need to get a new front radiator support, bumper brace, etc.

 

IF you will do it i would love to see it lol

 

The coupe fenders slope down more towards the bumber than the sedans do so bolting it on will not work. Also the coupe fender is narrower than the sedans. It would look great but I think it might cost too much to modify.

 

Nismo Sedan front > *

 

Doesnt fit on 05's...
-GP-

 

Coupe headlights>Sedan headlights

 

I know that much. I didn't mention bumpers because I wasn't planning on using a stock bumper. I was thinking it would be an easy way to "widebody" the front of the sedan, and you'd have a huge choice of bumpers, too!!! then, you'd have to have someone custom widen the rear fenders. Of course, I'd need to get a set of coupe headlights,too.

 

I have been looking through the factory parts catalogs and it looks like alot of the brackets are the same! it also appears that the front radiator support is identical,too!! this might be easier than I thought.......I might have to order up a fender to experiment.

 

how about the rear? ... you will then be wider in the front

 

I thought about this once... get the Ings+1 fenders!
I think the fenders, and possibly the hood, will be the only parts that will need to be modified (b/c of the door and A pillar).

 

the rear would have to be custom. my initial thought would be to buy g35 coupe reare quarter panels and cut the arched fenders out and have them welded/blended and some custom sheetmetal formed to finish it out for the sedan.

 

good luck with the project!

 

I think it would look hot QuadCam. Hopefully you can pull it off without too much work.

 

^^+1

 

I would love to see that...sounds interesting