hey guys, i recently changed my brakes to brembos which didnt clear my front wheels so i had to put oem back on (changed only passenger side front caliper). i bled properly and now have the brake, vdc, and slip light all on. disconnected the battery, no luck, tried resetting ecu, no luck. lights go off, and pop back up. wtf, help me out guys. thanks!

 

i think you disconnected the VDC connection. Connect the sensor up and you should be good.

 

Fluid levels ok? When it gets low all those go off.

 

^^^+ 1 on posts 2 and 3

 

fmlwtfbbq, love it BTW

 

+1 on checking your brake fluid level. My dash lights came on a few weeks agi, filled my brake fluid to "max" and they haven't come on since.

 

its your break fluid level

 

i only did my passenger front caliper.. nothing else was disconnected to my knowledge, but wouldnt hurt to check lol


it was between min and max, so should be but from what im reading i should top it off

just topped her off, ill give it a shot. thanks guys

 

If the fluid is between min and max it shouldn't kick the lights.

My bet is still on the VDC sensor. Take the wheel off and double check everything.

 

the abs lines might be pinched.

 

topped off the fluid, problem solved : )

now on startup car dips to almost zero and goes back to idle...any ideas lol?

 

^ lol always something

 

tell me about it. i thin its prolly just an 02 sensor or something. lucky me i have like 8 of them lying around lol.

 

car is learning ??

 

fixed you just signed up recently to chicago z right? find me on there boostin350z, and congrats on your buy!