Plenum Whistle
Plenum Whistle
Just installed a 5/8 plenum spacer, and Im getting a very high pitched whistle just as the car is in idle. Any ideas? Im going to try loosening the screws might be too tight causing the spacer to warp, but suggestions are welcomed.
Anyone else run into this problem?
Anyone else run into this problem?
did you use a torque wrench? the outside bolts must be torqued to 100 ft lbs and the inside bolts must be 80 ft lbs. i think that would be the first place to start if you didn't use a torque wrench. but yeah if the bolts are too tight you will warp the spacer and get the plenum whistle
2004 G35x, Motordyne 5/16" Copper Iso Thermal Plenum Spacer, Z-Tube with Pop-Charger, NGK Iridium, Mobil 1 Synthetic, EBC Green Stuff Pads with EBC 3GD Sport Rotors, Brake Master Cylinder Stiffener, OEM Spoiler, Grounding Kit, 235/50/17
2004 G35x, Motordyne 5/16" Copper Iso Thermal Plenum Spacer, Z-Tube with Pop-Charger, NGK Iridium, Mobil 1 Synthetic, EBC Green Stuff Pads with EBC 3GD Sport Rotors, Brake Master Cylinder Stiffener, OEM Spoiler, Grounding Kit, 235/50/17
Last edited by drkay; May 27, 2010 at 12:50 AM.
DO NOT torque to 100 ft lbs, it is INCH lbs and there is a specific order to do it in
http://www.motordyneengineering.com/manual.pdf
http://www.motordyneengineering.com/manual.pdf
did you use a torque wrench? the outside bolts must be torqued to 100 ft lbs and the inside bolts must be 80 ft lbs. i think that would be the first place to start if you didn't use a torque wrench. but yeah if the bolts are too tight you will warp the spacer and get the plenum whistle
^ INCH POUNDS!
Its different from foot pounds
100 inch pounds is 8.33 Foot pounds.
Trending Topics
It's like an alarm clock...woo wooooo!
Last edited by OKStateG35; May 27, 2010 at 09:56 AM.
"Iss only in da moaning, you should be up cooking brefass o' somethin'."
Haha, I was just recently introduced to it's greatness by my wife. I love it.
1. Only available in Oakland
2. Hurts performance because "Iss juss fo' decoration"



