That DIY is for a OE Nismo install.

The Strafe will be along the same lines minus a few steps and adding a few.

Strafe bumpers have the corner marker brackets molded in Poly with the bumper.

No need to transfer the brackets off your OE bumper.

Other than that it's a pretty straight forward install.

If you have any questions pm me I can try to answer any other concerns you may have.

 

What tool did you use to cut out the grill holes????

 

I used a drill with a few various bits and then finished cutting with a air body saw. Cleaned up the cuts with a dremel and some scotch brite pads.

 

That was fast shipping it it only took a week to get. I did u receive a tracking number after u placed the order?

 

Thank you sir for your help. It is greatly appreciated ...... out of curiosity, how much did you pay to have it painted??

 

Yeah, Shipping was pretty quick. I don't recall a tracking number on the invoice ...... I take it in next week for paint.

 

when u guys bought it from strafe it didnt come painted correct? How much was it for you guys to paint the bumper?

 

Well since I had a few things painted its hard to break down what the bumper itself cost.

I had my mudguards and OE sills painted. Then my Nismo sides painted cause I had purchased a mix matched set and both front and rear bumpers for $500 bucks.

It helps that I know the paint shop and did all the removal and install myself.

 

Should be a fun project for you. Post pis when your done.