abs slip and vdc lights
Thread Starter
|
Registered User
Joined: Oct 2013
Posts: 3
Likes: 0
abs slip and vdc lights
I have an 03 sedan, not too long ago I had a problem with my hub on my g while I was taking it to the shop the abs slip and vdc lights came on. I thought It was the hub , so I just let the mechanic change the both front hubs thinking that was going to turn the lights off. So when I got the car the light where still on. I hopped online and googled about it it said I needed to put brake fluid in the reservoir, when I got to the car the reservior was full. Then I kept googling and said that the abs sensor on the passenger front was messed up. So I changed it and really it looked like the hub messed it up the old one, but the lights wont turn off.. could someone help me and tell me how to reset this
Guest
Posts: n/a
I have them on sometimes on my 06 sedan. I'm pretty sure its brake pads that are worn. Will revert once they get changed out.
Had this happen on my old 350Z and it was the speed sensor that had gone out. No way to check which one but I changed out the front ones and it went away.
Either way, I'm going to get the pads changed out this weekend and I'll let you know if that is what it was.
These lights turn on for the following reasons:
1. Brake fluid is low
2. In need of a brake job (worn pads, warped rotors)
3. Speed/angle sensors are extremely dirty/or are faulty
4. VDC/Traction control module is out
5. VDC/Traction control relay is faulty
Hope this helps.
Had this happen on my old 350Z and it was the speed sensor that had gone out. No way to check which one but I changed out the front ones and it went away.
Either way, I'm going to get the pads changed out this weekend and I'll let you know if that is what it was.
These lights turn on for the following reasons:
1. Brake fluid is low
2. In need of a brake job (worn pads, warped rotors)
3. Speed/angle sensors are extremely dirty/or are faulty
4. VDC/Traction control module is out
5. VDC/Traction control relay is faulty
Hope this helps.
Registered User
Joined: Oct 2012
Posts: 3
Likes: 1
From: Houston, Tx
I have the VDC/Slip light on my 05 6psd. I just replaced rear rotors and brake pads two days ago. brake fluid is good. I still have my light on. I may a bad sensor or module . I will look into it, I'm going to try and hook up a code reader. I will let you know how mine goes.
Thread
Thread Starter
Forum
Replies
Last Post
Luisgalvan33
G35 Sedan V35 2003-06
3
Jul 19, 2018 08:16 PM
Luisgalvan33
New Members Check In
0
Jul 28, 2015 05:37 PM
Wayne9011
Engine, Drivetrain & Forced-Induction
2
Jul 27, 2015 11:25 AM
