Premiere Mobile ClearBra install (lots of pics)
#16
well, of course big rocks are still going to get through to your paint and chip/dent it. It is all the little things, sand and other small stones that would normally mess up your front end. Over time, things as small as sand will do alot of damage to your car. This, along with big damage is what the clear bra is for - not objects bigger than probably a dime, maybe even less.
#17
The clear bra will protect your front end paint from your everyday minor road nuisances. However, larger objects will probably get through the film. Tailgating and not being aware of what is in front of your vehicle is your worst enemy, in that event. In which case, nothing practical will preserve your cars' finish.
#18
Originally Posted by ABQ_G35
I had my entire front bumper done with 3M Scotchgard Paint Protection film for $250 by a 3M certified dealer, the hood nose mask was done by them too, but the dealer had that done. I wouldn't attempt applying anything like this DIY, it's an art!
Not NOR CAL by anyt chance huh???
ZX.......
#21
Originally Posted by norcalG35er
$250-$690? Isn't that a big spread for a similar job?
#22
For $250, that is cheap by comparison. What type of coverage did you get? Here in California, there are plenty of competitors charging much less than what we chg, but the quality of installation is what makes or breaks the visibility level. There are companies using cheaper "kits" (multi-pc for the front bumper or less coverage on the hood) because certain vehicles are too tough for the average installer to lay the film down in one piece.
Here are some pics of exotics we work on a daily basis that's full custom (non pre-cut) that costs anywhere from double to 20 times the cost of the Gs.
Here are some pics of exotics we work on a daily basis that's full custom (non pre-cut) that costs anywhere from double to 20 times the cost of the Gs.
#23
#24
Mine was done one piece, not a kit, the entire front bumper is covered, and like I said, the hood was done by the dealer, so I don't know what the cost was, the shop has been in business for many years, and does all the Infiniti, Lexus, BMW and Mini dealers tint and trim here. I didn't know people would do the entire car, I don't think I would like that. How hard is it to do all the nooks and extreme curves?
Last edited by ABQ_G35; 07-31-2005 at 10:24 PM.
#25
Originally Posted by zx7biker
What state did you get yours done at??
Not NOR CAL by anyt chance huh???
ZX.......
Not NOR CAL by anyt chance huh???
ZX.......
#26
Thread
Thread Starter
Forum
Replies
Last Post