Wheel bearings and warranty
#17
Actually that was a typo. I did replace the entire hub assembly, not just the wheel bearing, as I don't have access to a press and didn't want to a re-use a part that looked so corroded just to save a bit of money.
A tip to DIYs: make sure you use a torque wrench and be very careful when removing the hub as the speed sensor looks like it may break very easily with any impact
I really owe all this success to these articles:
https://g35driver.com/forums/brakes-...-bearings.html
http://www.nicoclub.com/archives/rep...ti-g35-g3.html
A tip to DIYs: make sure you use a torque wrench and be very careful when removing the hub as the speed sensor looks like it may break very easily with any impact
I really owe all this success to these articles:
https://g35driver.com/forums/brakes-...-bearings.html
http://www.nicoclub.com/archives/rep...ti-g35-g3.html
Last edited by aeroheli; 06-24-2012 at 08:50 AM.
#18
Ahh, ok, when you mentioned the Timken bearing I just thought . . .
But anyway, there is another DIY right here for our cars that is quite good with lots of pics:
https://g35driver.com/forums/g35-sed...aring-diy.html
(A little late for you, but perhaps useful to anyone who arrives here from a search)
But anyway, there is another DIY right here for our cars that is quite good with lots of pics:
https://g35driver.com/forums/g35-sed...aring-diy.html
(A little late for you, but perhaps useful to anyone who arrives here from a search)
Thread
Thread Starter
Forum
Replies
Last Post
rezendvous420
G35 Sedan V35 2003-06
10
05-31-2020 01:26 PM