you need to ditch this shiny shiiit and boost the car! so much more fun lol

 

I am literally doing this right now, no knowledge of DD doing it though lol.

Here is your link through a mobile connection:

http://www.ebay.com/ulk/itm/131337287758

It's the black OEM style replacement.

Btw there is fitment issues its not all sunshine and daisies to swap in, but the three retaining screws do work!

 

How bout shinny and boosted? Then you can be on my level lmao.

Urban, a did you do the lights as well?

Frankie, make sure to buy some extra sealant. I went back and replaced mine, which made it seal nicely. Especially in this area below. But all the screws should work.

Rubber sealant: http://www.theretrofitsource.com/accessories/morimoto-retrorubber-butyl-glue-50254.html

 

Yes as above ^^^ you may consider cutting off the little alignment nubs too. DD, I literally bought the same pair lol.

 

Update us on your progress. I just noticed frank said 04. Mine were 06. So might be a slight difference in housings

 

Updated all the images in the thread. Seen a few were outdated.

 

I meant my 04 lenses onto my 06 projectors.. What else didnt line up with the swap?? Mine has that same gap on top, I guess the 04 and 06 are shaped different

 

Oh ok, I thought you meant 04 housings. Yeah, they are shaped a little different. If you used newer rubber, then they should seal fine.

 

Yeah when I got my lights done they put new silicone on them for me.. So that was it just the top being shaped different?? Everything else is good??

 

Yeah, everything else was good.

 

Nice, Gonna order them when I get back in town..

 

where you be? i gotta text you my new #

 

Im in Illinois, about 25 minutes from St Louis.. Text it to me

 

Ha, I'm from IL. But florida man now. That close, then you are near Edwardsville or alton I would guess.

 

Nice DD, I had always wounded if this was possible. Thanks for inspiring my next DIY project.