no crank no start just click Please help I change the main line pressure control solenoid in the valve body, and after putting the valve body back in I made sure all connectors and everything we're in the right places but now. My 10a AT Cont Fuse blows when I turn the ignition to the on position and I get a u1001 and u1000 code. The code only shows up when the fuse blows and when the fuse doesn't blow there are no check engine codes at all.

 

Did you maybe pinch a wire when you were reinstalling the VB?

 

I don't think so. I know I shouldn't do it but I put a 20a fuse in where the 10a is for AT Cont and no check at light comes or or anything at all and it'll try and turn over. The battery I have in the car is a 35 type but it is smaller than the original battery that I had in the car at first so I thought it could've been that but it won't even star with a jumpstart.

 

I was thinking the same thing. I did that once on a RE4 trans and grounded 1 solenoid out.

 

Those codes finally went away my battery was to small. Now the only code im getting is p0745 the line pressure control solenoid. I changed this once before because I first had that code I might've changed the solenoid to another bad one. I will have to do it again and the new solenoid I got measured 13-14 ohms