After thinking about it, I'll have to pass on the plenum polishing since it'll take so much work to get my engine bay to anything worth being proud of. Thanks again for putting this group buy together and for the excellent quality.

 

I got mine in at about 3pm this afternoon but I had work and didnt have time to post up pictures earlier. All in all tho this install was very straight forward and took probably an hour(including eating and d1cking around a little). So far I havent zip tied any of them yet and I tried to follow seans guide to the T. I had a buddy help me out on this so it was pretty easy all together.


Review: I noticed a pretty good improvement in shifting in the Manumatic mode. Some other said the lights and radio were louder and brighter but I didnt really notice. It looks very clean in my engine bay but now I need to polish everything and get it show car worthy. Hopefully.....







I will be going back over this and checking all the wires and such so Sean if you notice anything out of the ordinary can you please let me know. I was in a major rush to get to work so I didnt have as much time as I would have liked.

Thanks again Sean

 

i was going to wait to do mine for a while cause i figured i would have to take my car in for warranty work since i was sure oil was getting on the spark plug boots, but as i checked them today, all of them were bone dry. so while i had it all torn apart and it wasnt going to need to go to the dealer, i figured id put the kit on, it was very easy and didnt take very long. SxExCx, if you see any areas where a wire is touching something it shouldnt be, let me know. my engine bay is nothing special...

 

Got mine today! I won't be able to install them until Monday though. Thanks again Sean!

 

On wire #4, you wrapped it under the factory wire loom. It looks like it is now touching the oil sensor which gets very hot. Just ziptie it so it follows the TOP of the factory loom.

 

i want 20% of tooo, lol not sure how many ppl bought from canada, but do we count as our own region? lol i never got it in the mail yet though

 

#4 isnt touching anything but the wire loom but i will probably take your advice anyway just to make sure, thanks bud

 

Your air fliter looks a little dirty

 

Sean do you mind PM'in me a color photo of the AT only wire where it attaches under car...I have all the other wires on but when i got to jackin car up nd squeezing under it was rainy pretty hard and 12AM lol so it was hard to spot and to make matters worse the directions became soaked and covered with dirt and crap....i only need the one picture tho where it attaches to tranny.....its on passenger side right where that big black box is???

 

You don't have an X, do you?

 

^^^^^^^ naw he has a coupee

 

its a 10mm bolt on the passenger side of the trans just above the tran fluid pan, it secures a little id tag to the trans.

 

good eye! its not as dirty as the picture makes it seem, but its not spotless either, these filters get dirty so fast on these cars!

 

yea im sure if it wasnt raining and i wasnt laying in mud i would have found it haha...so if i peak under and see big black tran fluid pan its on the side of that but up ?...if its got a tag i should be able to see it



and yes for now My AT wire is wrapped around strut bar

and thanks again Sean this Grounding kit is AWESOME!!!!!!....when ppl ask about it ill direct them to you....(G owners of course)

 

^PMed