Hi guys, I jst resently had my car over heat, so I flushed out my coolant replaced my thermostat and replaced the oil. My SES is still on. Anyone know how to reset this?

Thanks in advance.,

 

Why not get a code reader and find out why it's on??

 

how can a car guy who mods cars not even know how to reset the ses light ?

 

I got a reader if u need

 

turn car off first.

turn key or push ignition button to on... but not started.

Count 3 seconds

Push gas pedal all the way to floor and release 5 times in 5 seconds. Release pedal after 5th one.

Wait 7 seconds and then press gas pedal down for 10 seconds. CEL light should blink.

Release pedal and wait 10 seconds.

Depress pedal again and hold for more than 10 seconds.

Release pedal and turn ignition off then turn ignition all the way to start. CEL should clear.

Timing is critical and if you are off a little...this obviously will not work.

Though...you should get a code reader just in case as well.

Hmmm.....didnt see the post date. This may be old already I suppose

 

did u replace ur rad cap too while u were at it? thats pretty important from what ive read online in the past