anyone know how to pull codes from the G coupe when the sES light comes on?

 

Don't you need a scanner to pull codes?

My SES light, VDC off light, and SLIP light turned on at the same time last week and when I took the car in to the dealership they replaced a throttle sensor under warranty.

 

Mark... I'll try call up my buddy with the scanner... He has one for his G... but yah... hopefully his number is the same...

 

yeah, just plug the scanner in on the left of the steering wheel just below the vdc button crap.

 

count the numbers of blinks.
Do the ECU reset but dont clear the codes
1. turn ignition on
2. count 3 seconds
3. step on the pedal 5 times in 5 seconds
4. wait 7 seconds
5. step on the pedal till the CEL starts blinking.

From there the first long blink is the indicator blink followed by a series of short blinks with short pauses in the middle.
ie. 1 long blink - pause - 6 short blinks - 6 short blinks.
that indicate you have a P0166 code. If you have multiple codes -
ie. 1 long blink - pause - 6 short blinks - 6 short blinks - pause - 1 long blink -pause 7 short blinks - pause - 2 short blinks.
that would indicate you have 2 codes, P0166 and P0172.
Then refer to http://www.troublecodes.net/OBD2/Pcodes.shtml

 

thanks 636. not very good at the pedal dance. i'll give it a try though. site seems to be down for the trouble shoot codes though. where can i get a scanner? i'm thinkin i should pick one of these up already.

 

places like ron's, checkers, and online (best place). i have a book on codes at work, and i'll try to scan some of the pages as time permits.

 

so basically its a universal obd2 scanner? doesn't checkers scan ur car for free?

 

hit me up I have a OBD2 scanner with CAN. where are you located?

 

^... hey DHC... I lost your number... but i told beanz about how you had the scanner...

 

y0 bean...your private messages inbox is full.