I got the Z tube and JWT pop charger installed over the weekend, but I had issues with putting the rubber edge trim onto the open end of the stock air scoop. I get it on, but there is a bit of overlap. I used a pencil to see if I pushed it down all the way into the groove and all of it is fine except for one small section, though it's not enough to have the large overlap that I have. Any suggestions?

The Overlap



Just to verify, I am putting it on correctly right?

 

cut it.

 

I was honestly thinking about doing that. I just figured it would fit on as is. Easy fix...thanks

 

yea they arent going to fit 100%. youll be fine.

 

+1^ cut it

 

Fits like a charm Thanks again!

 

Our temps here are high so first time I installed my trim, in about a year I noticed the trim had fallen off.

I bought new trim from Ben Pila at JWT and superglued it onto the heatshield and scoop. 8 months later the trim is still on.