just installed 5/16 spacer minor issues
#1
just installed 5/16 spacer minor issues
so i just installed the spacer and had a couple issues guys. first off when i first started the car it kept "hiccuping" and wouldnt start. so i figured air leak, so i went to osh and actually bought a torque wrench
http://www.sears.com/shc/s/p_10153_1...orque+Wrenches
as i set it to 40 inch pounds and tightening, it got to the point where i though i was gonna snap the bolts. how do i know when to stop? how do use this torque wrench? im an obvious newb so any help would be great.
other issue i had was i snapped the post bolt for my injen intake. what the wasiest way to take it out. thanks.
http://www.sears.com/shc/s/p_10153_1...orque+Wrenches
as i set it to 40 inch pounds and tightening, it got to the point where i though i was gonna snap the bolts. how do i know when to stop? how do use this torque wrench? im an obvious newb so any help would be great.
other issue i had was i snapped the post bolt for my injen intake. what the wasiest way to take it out. thanks.
#3
Registered User
iTrader: (25)
That's the same torque wrench I bought to install my spacer too, lol. You just set it to the amount of torque you want, lock it there, then just turn the wrench until you hear/feel a "click" to let you know when to stop. The amount of force needed for the plenum bolts really isn't much at all, so be careful not to over-torque and break them. Good luck!
#4
#5
Thread
Thread Starter
Forum
Replies
Last Post
bu villain
19 Inch
3
11-15-2015 09:23 PM